262
Chapter 10
Command Reference
E4981A SCPI Commands
[:SENSe][:FIMPedance]:RANGe[:UPPer]
Syntax
[:SENSe][:FIMPedance]:RANGe[:UPPer]
{1p|2.2p|4.7p|10p|22p|47p|100p|220p|470p|1n|2.2n|4.7n|10n|22n|47n|100n|220n|470n|1
μ
|2.
2
μ
|4.7
μ
|10
μ
|22
μ
|47
μ
|100
μ
|220
μ
|470
μ
|1m}
[:SENSe][:FIMPedance]:RANGe[:UPPer]?
Description
Sets the measurement range.
When you set the measurement range with this command, the measurement range mode is
automatically set to the hold range (specified to OFF with the
[:SENSe][:FIMPedance]:RANGe:AUTO
NOTE
The measurement range varies depending upon the frequency setting.
Parameters
If one of the settable values is not specified for the parameter, a suitable measurement
range whose recommended range includes the specified parameter (for example, 10E-9 if
the specified parameter is 5E-9) is set.
MAX or MIN can be used to specify the parameters.
Query response
{1pF|2.2pF|4.7pF|10pF|22pF|47pF|100pF|220pF|470pF|1nF|2.2nF|4.7nF|10nF|22nF|47nF|
100nF|220nF|470nF|1
μ
F|2.2
μ
F|4.7
μ
F|10
μ
F|22uF|47
μ
F|100
μ
F|220
μ
F|470
μ
F|1mF}
<newline><^END>
If the measurement range mode is Auto, the measurement range used in the immediately
preceding measurement is read out as the query response.
Related commands
[:SENSe][:FIMPedance]:RANGe:AUTO on page 261
Equivalent key
sequence
[
Meas Setup
] - RANGE - AUTO|HOLD
<numeric>
Description
Measurement Range
Range
120 Hz: 10 nF - 1 mF
1 kHz: 100 pF -
100
μ
F
1 MHz: 1 pF-1 nF
Initial Value
100
μ
F
