Keysight Technologies E4981A, Programming Manual

Page: 187 / 383

Chapter 10 185
Command Reference
E4981A SCPI Commands
10
. Comm
and
Refe
ren
ce
:CALCulate1:COMParator:SECondary:LIMit
Syntax :CALCulate1:COMParator:SECondary:LIMit <numeric 1>,<numeric 2>
:CALCulate1:COMParator:SECondary:LIMit?
Description Sets the limit range for the secondary parameter used in the comparator function.
This command only sets the limit range. To activate the set limit range, use the
:CALCulate1:COMParator:SECondary:STATe command to enable sorting judgment for
the measurement result of the secondary parameter.
Parameters
If the specified parameter is out of the allowable setup range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric 1},{numeric 2}<newline><^END>
Related commands :CALCulate1:COMParator:SECondary:STATe on page 186
:CALCulate1:COMParator:PRIMary:BIN{1-9}[:LIMIT] on page 182
:CALCulate1:COMParator[:STATe] on page 187
Equivalent key
sequence
[
Meas Setup
] - LIMIT TABLE - BIN|2nd - LOW, HIGH
<numeric 1> <numeric 2>
Description The lower limit value of the
limit range.
The upper limit value of the
limit range.
Range -99.9999E9 to 99.9999E9 -99.9999E9 to 99.9999E9
Initial value 0 0
Unit Depends on the type of
parameter.
Depends on the type of
parameter.