Keysight Technologies E4981A, Programming Manual

Page: 184 / 383

182 Chapter 10
Command Reference
E4981A SCPI Commands
:CALCulate1:COMParator:PRIMary:BIN{1-9}[:LIMIT]
Syntax :CALCulate1:COMParator:PRIMary:BIN{1|2|3|4|5|6|7|8|9}[:LIMIT] <numeric
1>,<numeric 2>
:CALCulate1:COMParator:PRIMary:BIN{1|2|3|4|5|6|7|8|9}[:LIMIT]?
Description Sets the low and high limit ranges of BIN1 to BIN9 as the primary parameter used in the
comparator function, depending on the designation method set using the
:CALCulate1:COMParator:MODE command.
This command only sets the limit range. To activate it, use the
:CALCulate1:COMParator:PRIMary:BIN{1-9}:STATe command to turn on the BIN for
which the limit range has been set.
Parameters
If the specified parameter is out of the allowable setup range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
NOTE The unit of the parameter may change depending on the limit range designation method.
Query response {numeric 1},{numeric 2}<newline><^END>
Related commands
:CALCulate1:COMParator:MODE on page 181
:CALCulate1:COMParator:PRIMary:BIN{1-9}:STATe on page 183
:CALCulate1:COMParator:SECondary:LIMit on page 185
:CALCulate1:COMParator[:STATe] on page 187
Equivalent key
sequence
[
Meas Setup
] - LIMIT TABLE - BIN{1|2|3|4|5|6|7|8|9}- LOW, HIGH
<numeric 1> <numeric 2>
Description The lower limit value of the
limit range.
The upper limit value of the
limit range.
Range -999.999 to 999.999 -999.999 to 999.999
Initial value 0 0
Unit F (farad) or % (percent) F (farad) or % (percent)