IAI SCON-CB-F, Instruction Manual

Page: 271 / 450

255
4.2 RCON Connection Type
This can be used as a driver unit that operates SCON-CB/CGB with commands from RCON
Gateway.
16 axes
(Note1)
can be connected at the maximum with one unit of RCON Controller. (One unit of
the extension unit is necessary. P Driver Unit, A Driver Unit and D Driver Unit should be included
as a number of axes in the 16 axes.)
4.2.1 Model Codes for RCON Connection Type
RCON Connection Type SCON-CB/CGB controllers are only available to connect.
Servo-pressing type (SCON-CB/CGB-F) and logic controller type (SCON-LC/LCG) are not
available to connect.
The model codes for RCON Connection Type SCON are expressed as shown below;
●SCON-CB/CGB-□-RC-□
4.2.2 Connection to RCON
Follow the figure below for wiring.
Connection between RCON extension unit and SCON Controller and between SCON
Controllers should be established with the same connection cables. (CB-RE-CTL□□□: Refer to
4.2.7 (1)) C in SCON Controller has IN on lower end and OUT on upper end. Pay attention not
to connect other way around. It is necessary to connect the terminal connector
(RCON-EXT-TR: Refer to 4.2.7 (2)) at the terminal.
Note 1 There may be a case 16 axes cannot be connected depending on combinations of linked
driver units. Refer to the section of restrictions in unit connection in RCON System
Instruction Manual (ME0384) for details.
RCON Controller
Extension Unit
RCON Connection
Communication
Connector
Upper End: OUT
Lower End: IN
Connection Cable: CB-RE-CTL□□□
SCON-CB/CGB Controller
Actuator
Cable for Each Actuators
Terminal Connector
RCON-EXT-TR
Total Cable Length: 10m Max. Length of Cables between Devices: 3m Max.