6-4
e. INSTALLATION
1) Install the silencer duct assembly on the silencer case.
2) Set the four 6 mm washers and the four 6 x 25 mm flange
bolts, then tighten the four 6 x 25 mm flange bolts securely.
3) Set the breather tube in the 18.5 mm clamp and the guide
of the silencer duct assembly.
4) Secure the pressure regulator control tube with the two 3.5
mm tube clips of the silencer duct assembly.
Connect the pressure regulator control tube aligning the
marked part on the tube with the end of the 3.5 mm tube
clip (P. 2-71).
5) Install the main wire harness’ harness band clip on the
silencer duct assembly.
6) Install the engine cover (P. 4-2).
6 x 25 (4)
[1]
6 mm
WASHER (4)
[2]
SILENCER DUCT
ASSEMBLY
[2] SILENCER
DUCT
ASSEMBLY
[7]
3.5 mm TUBE
CLIP (2)
[4]
PRESSURE
REGULATOR
CONTROL
TUBE
[3]
18.5 mm CLAMP
[8]
GUIDE
[1]
BREATHER
TUBE
[5] MAIN WIRE
HARNESS
[6] HARNESS
BAND CLIP