11-5
10) Then, tighten it to the specified torque using the same
special tool as that used during disassembly.
TOOL:
Oil filter wrench
07HAA-PJ70101
TORQUE: 12 N.m (1.2 kgf.m, 9 lbf.ft)
11) Before installing the EOP switch (low pressure side), clean
the switch and apply the liquid gasket (ThreeBond
®
#1215
or equivalent) to the area shown.
Take care not to put the liquid gasket on the switch end and
the oil passage.
NOTICE
12) Tighten the EOP switch (low pressure side) to the specified
torque using the torque wrench.
TORQUE: 8 N.m (0.8 kgf.m, 5.8 lbf.ft)
Use the torque wrench to tighten the EOP switch (low
pressure side). Do not overtighten the EOP switch as it can
damage the oil filter flange.
13) Connect the EOP switch terminal to the EOP switch (low
pressure side).
14) Add the specified amount of the engine oil (P. 3-2).
After adding the oil, check each joint for oil leakage.
15) Install the following parts.
– L./R. engine under covers (P. 4-14)
– Engine cover (P. 4-2)
NOTICE
[1]
APPLICATION
AREA
[2]
EOP SWITCH
(LOW PRESSURE SIDE)
[1]
EOP SWITCH
TERMINAL
[1]
OIL FILTER
WRENCH
07HAA-PJ70101
