18-9
• MAGNETIC SWITCH
After assembly, check for continuity between the S terminal
and the yoke (ground). Check for continuity between the S
terminal and the M terminal.
d. ASSEMBLY
After assembling the starter motor, apply sufficient amount of
the water resisting sealant (Sumitomo 3M Padding Sealer
#8533 or equivalent) to the mating sections of each part (P. 17-
19).
NOTICE
[3]
GASKET
[20]
PLUNGER
[19] PLATE
[21]
CLUTCH FORK
[18] SPRING
[16]
GASKET
[15]
8 mm WASHER-NUT
[5]
PLATE
[25]
SNAP RING
[24]
GEAR SHAFT
STOPPER
[8]
ARMATURE
[6]
REAR BRACKET
[14]
PLANETARY
GEAR (3)
[17]
STARTER MAGNETIC
SWITCH
[10]
OVERRUNNING
CLUTCH
[11]
INTERNAL GEAR
[12]
GEAR SHAFT
[13]
STEEL BALL
[1] S TERMINAL
[2]
M TERMINAL
[1]
BRUSH HOLDER
[2]
BRUSH SPRING (4)
[22]
FRONT BRACKET
[4]
BRUSH SET
Replace as a set.
[7]
5 x 8 mm SCREW (2)
[26]
6 x 22 mm SCREW (2)
[23]
O-RING (2)
Do not reuse.
[9]
THROUGH BOLT (2)
[27]
YOKE
ASSEMBLY:
Check the inner wall of the
magnetic part for the foreign
material (nut, washer, etc.)
before assembly.
6 N.m (0.6 kgf.m,, 4.3 lbf.ft)
2.5 N.m (0.25 kgf.m, 1.8 lbf.ft)
5 N.m (0.5 kgf.m, 3.6 lbf.ft)
