14-65
15) Place the wood block under the forward bevel geaar.
16) Place the bearing holder assembly on the forward bevel
gear.
17) Apply gear oil to the inner wall of the taper bearing inner
race and position it in the forward bevel gear.
18) Install the taper bearing inner race on the forward bevel
gear using the special tools and hydraulic press.
TOOLS:
Driver
07749-0010000
Attachment, 62 x 68 mm
07746-0010500
Install by applying gear oil between the inner and outer
races of the taper bearing.
NOTICE
19) Apply gear oil to the threads and seat of the bearing holder
assembly.
20) Position the bearing holder assembly on the propeller
shaft.
Loosely tighten the bearing holder assembly by hands
against the propeller shaft holder.
21) Attach the fixing tool, that had been used during propeller
shaft/propeller shaft holder removal, on the propeller shaft
holder assembly and secure with the bolt.
22) Tighten the bearing holder to the specified torque using the
special tool as shown.
TOOL:
Pin spanner wrench, 110 mm
07WAA-S1G0100
TORQUE: 191 N.m (19.5 kgf.m, 141 lbf.ft)
Avoid holding the propeller shaft holder directly in a vise.
Use the fixing tool to hold it in a vise.
NOTICE
[1]
DRIVER
07749-0010000
[2]
ATTACHMENT,
62 x 68 mm
07746-0010500
[4]
FORWARD
BEVEL GEAR
[5]
BEARING
HOLDER
ASSEMBLY
[6]
50 x 90 x 28 mm
TAPER BEARING
(INNER RACE)
[1]
BEARING
HOLDER
ASSEMBLY
[3]
WOOD BLOCK
[2]
PIN SPANNER
WRENCH, 110 mm
07WAA-S1G0100
[4]
FIXING TOOL
[3]
PROPELLER SHAFT
HOLDER ASSEMBLY
