15-17
9) Remove the 15 mm E-ring from the upper cylinder pin. Remove the upper cylinder pin and the piston rod of the
power trim/tilt assembly from the swivel case assembly.
Check the upper cylinder bushing mounted on the piston rod of the power trim/tilt assembly. If it is damaged, replace
with a new one.
10) Remove the upper cylinder bushing.
Replace with a new one on assembly.
[3]
SWIVEL CASE
ASSEMBLY
[4] PISTON ROD
[2] UPPER CYLINDER PIN
[1] 15 mm E-RING (2)
11) Remove the two 6 x 20 mm hex. bolts and the two 6 mm
washers from the trim angle sensor, and remove the trim
angle sensor.
[3]
6 mm WASHER (2)
[2]
6 x 20 mm HEX.
BOLT (2)
[1]
TRIM ANGLE
SENSOR
[5] UPPER CYLINDER
BUSHING (2)