14-45
7) Apply grease to the vertical shaft spline and the shift rod
spline.
Apply grease to the water tube insertion part and to the
inner wall of the water tube seal ring of the impeller
housing.
Apply grease to the inner wall of the vertical shaft bushing
[XCC and XCD types only] (P. 14-90).
8) Install the two dowel pins. Aligning the water tube with the
water tube seal ring of the impeller housing, install the
vertical shaft and the crankshaft. Install the shift rod and
shift rod A, too, by aligning the splines.
9) Install the gear case assembly on the outboard motor.
Loosely tighten the seven 10 mm washers and the seven 10
x 40 mm hex. bolts.
10) Connect the speed sensor tube B and the speed sensor
tube C.
11) Lower the outboard motor to the lowermost position and
tighten the seven 10 x 40 mm hex. bolts to the specified
torque.
TORQUE: 34 N.m (3.5 kgf.m, 25 lbf.ft)
12) Position the gear case cover on the gear case assembly.
13) Install the gear case cover aligning the “
” mark on the
gear case cover with the “
” mark on the gear case.
Tighten the 10 mm washer and the 10 x 32 mm hex. bolt.
14) After installing the gear case assembly, adjust the shift
[2] “
” MARKS
[3]
10 x 32 mm
HEX. BOLT
[4]
10 mm WASHER
[2]
SPEED SENSOR
TUBE C
[1] SPEED SENSOR
TUBE B
[1] GEAR CASE COVER
[2]
VERTICAL
SHAFT
[1]
WATER TUBE
[5]
GEAR CASE
ASSEMBLY
[6]
10 x 40 mm
HEX. BOLT (7)
[7]
10 mm
WASHER (7)
[3]
WATER TUBE
SEAL RING
[4]
6 x 10 mm
DOWEL PIN (2)
