BF135A•BF150A
5-124
14) Tighten the four 5 mm screw-washers securely.
• Install the connector bracket in the position shown and
secure with the two 5 mm screw-washers.
TORQUE: 3.4 N
•
m (0.35 kgf
•
m, 2.4 lbf
•
ft)
15) Apply the engine to the new O-ring and install it on the
strainer cover.
16) Install the spring and the fuel strainer, and install the strainer
cover.
• Install the fuel strainer in the direction shown.
17) Tighten the 5 mm washer screws securely.
TORQUE: 3.4 N
•
m (0.35 kgf
•
m, 2.4 lbf
•
ft)
18) Apply the engine oil to the new O-rings and install them on
the collar.
19) Install the collar on the strainer cover.
20) Set the fuel hose and secure it by tightening the 6 x 25 mm
flange bolt.
21) Using a new sealing washer, tighten the service check bolt
to the specified torque.
TORQUE: 12 N
•
m (1.2 kgf
•
m, 9 lbf
•
ft)
[1] FUEL HOSE
(HIGH PRESSURE
SIDE)
[5]
COLLAR
[2] O-RING (2)
[3] SEALING WASHER
6 x 25
[2]
SEAL
[3]
PUMP COVER
[4] FILTER
SPRING
[1]
STRAINER
COVER
[3] FUEL STRAINER SET
[2]
CONNECTOR
BRACKET
[1] 5 mm SCREW-WASHER (4)
3.4 N·m (0.35 kgf·m, 2.4 lbf·ft)
[6] 5 mm SCREW (3)
[4]
SERVICE
CHECK BOLT
[5] O-RING
Do not reuse.
Do not reuse.
Do not reuse.
