15-47
32) Apply Automatic Transmission Fluid (ATF) to the new O-
ring and install it on the cylinder comp.
33) Install the oil tank on the cylinder comp. and tighten the
three hex. bolts to the specified torque.
TORQUE: 5 N.m (0.5 kgf.m, 3.6 lbf.ft)
34) Remove the oil tank cap. Pour fresh Automatic
Transmission Fluid (ATF) to the upper limit of the oil tank
filler port.
Do not overfill with Automatic Transmission Fluid (ATF).
Pouring the Automatic Transmission Fluid (ATF) while it is
flowing out of the filler port will overfill the tank, and that
will damage the oil seal of the motor when each rod is
compressed.
35) After filling the oil tank with Automatic Transmission Fluid
(ATF), bleed air from the power trim/tilt assembly <without
mounting on the outboard motor> (P. 15-48).
36) Tighten the oil tank cap to the specified torque.
TORQUE: 2.5 N.m (0.25 kgf.m, 1.8 lbf.ft)
NOTICE
31) Set the four hex. bolts on the power tilt motor assembly
and tighten the bolts to the specified torque.
TORQUE: 5 N.m (0.5 kgf.m, 3.6 lbf.ft)
[2]
HEX. BOLT
(3)
[1] OIL TANK
[3] O-RING
(ATF)
Oil capacity
0.68
R
(0.72 US qt, 0.60 Imp qt)
[2]
UPPER
LIMIT
[1]
OIL TANK CAP
[3] PUMP
ASSEMBLY
[2]
POWER TILT
MOTOR
ASSEMBLY
[1] HEX. BOLT (4)
