15-24
7) Remove the three grease fittings from the swivel case.
8) Remove the two 10 mm self-locking nuts and the two 10
mm washers, then remove the two thrust receivers.
[5]
THRUST
RECEIVER (2)
[4] 10 mm
WASHER
(2)
[3] 10 mm
SELF-
LOCKING
NUT (2)
[1] GREASE
FITTING (3)
[2] SWIVEL CASE
9) Remove the 6 x 14 mm hex. bolt, and remove the detent
assisted spring and the detent spring.
10) Using a commercially available 2.5 mm pin driver, drive out
the 2.5 x 20 mm spring pin to the position where it does not
interfere with the swivel case as shown.
Remove the driven-out 2.5 x 20 mm spring pin using the
cutting pliers or equivalent tool.
Remove the spring pin on the other side in the same
manner.
11) Remove the two tilt stoppers and the tilting bracket.
Check the tilt arm bushings mounted on the swivel case.
Replace them with the new ones if they are damaged.
12) Remove the tilt arm bushings.
Replace the tilt arm bushings with the new ones on
assembly.
[8] TILT ARM
BUSHING (2)
[9]
SWIVEL
CASE
[6]
TILTING
BRACKET
[7]
TILT STOPPER (2)
[2]
2.5 x 20 mm
SPRING PIN
(2)
[1]
2.5 mm PIN
DRIVER
(Commercially
available)
[3]
DETENT
SPRING
[5]
DETENT ASSISTED
SPRING
[4]
2.5 x 20 mm
HEX. BOLT
[2] 2.5 x 20 mm
SPRING PIN (2)
