15-19
16) Remove the 25 x 2.0 mm self-locking nut or 7/8-14 UNF self-locking nut from the tilting shaft.
Replace the 25 x 2.0 mm self-locking nut or 7/8-14 UNF self-locking nut with a new one on assembly.
17) Remove the tilting shaft and remove the L./R. stern brackets, two 26 mm wave washers and the swivel case assembly.
Check the swivel case bushing that is mounted on the swivel case assembly.
Replace the swivel case bushing if it is damaged.
18) Remove the swivel case bushing.
Replace the swivel case bushing with a new one on assembly.
19) Remove the 15.54 x 2.26 mm O-ring from the tilting shaft.
Replace the O-ring with a new one on assembly.
Remove the wire harness clip from the L. stern bracket.
[9]
25 x 2.0 mm SELF-
LOCKING NUT
[10] 26 mm WAVE
WASHER (2)
[6] R. STERN
BRACKET
[7] L. STERN
BRACKET
[4] TILTING SHAFT
[11] SWIVEL CASE
BUSHING
[1] SWIVEL CASE ASSEMBLY
[3] TILTING BOLT
CAP
[2]
7/8-14 UNF SELF-
LOCKING NUT
b. INSPECTION
• TRIM ANGLE SENSOR
Attach the tester leads to the trim angle sensor connector and
measure the resistance.
[5] 15.54 x 2.26 mm
O-RING
[8] WIRE HARNESS
CLIP
[1] TRIM ANGLE SENSOR
3P CONNECTOR
Resistance between
4 – 6
Ω
Light green/black and Black
Resistance between
2.7 – 4.3 k
Ω
Yellow/blue and Black
