15-38
10) Check that the left and right piston rods are in the fully
extended position.
11) Loosen the rod guide comp. fully using the special tool as
shown.
TOOL:
Pin wrench, 4 mm
07SPA-ZW10200
12) Remove the rod guide comp. and the piston rod Bs from
the trim cylinders slowly.
• Do not push the piston rod Bs into the trim cylinders.
13) Drain the Automatic Transmission Fluid (ATF) from the trim
cylinders.
Remove the rod guide comps from the piston rod B.
8) Remove the internal circlip and remove the manual valve
from the pump assembly.
Check the manual valve and the O-ring for deterioration,
wear and damage. Replace them if necessary.
Replace the manual valve with a new one on assembly.
[3] PUMP ASSEMBLY
[2]
MANUAL
VALVE
[1] INTERNAL
CIRCLIP
9) Set the cylinder comp. in a vice as shown.
Do not tighten the vice excessively, as it can damage the
cylinder comp.
NOTICE
[1]
ROD GUIDE
COMP.
[2] PIN WRENCH, 4 mm
07SPA-ZW10200
[1] VICE
[2]
CYLINDER COMP.
[2] PISTON
ROD B (2)
[1]
ROD GUIDE
COMP. (2)
