![background image](http://html1.mh-extra.com/html/honda/marine-bf135a/marine-bf135a_manual_2157757576.webp)
15-13
6) Connect the trim angle sensor 3P connector and the power
tilt motor 2P connector.
Install the power tilt motor 2P connector on the lower side
of the connector bracket A and the trim angle sensor 3P
connector on the upper side of the connector bracket A.
7) Install the following parts.
– Starter cable (P. 18-17)
– Remote control cable/grommet (P. 17-5)
– Gear case assembly (P. 14-5 and 44)
– L./R. engine under covers (P. 4-14)
– Engine cover (P. 4-2)
[1] UNDER COVER
FRONT BRACKET
[5]
HOLE
[4] UNDERCASE
GROMMET C
[2]
WIRES
[3]
TUBE
[3]
CONNECTOR
BRACKET A
[2] TRIM ANGLE
SENSOR
3P CONNECTOR
[1] POWER TILT MOTOR
2P CONNECTOR
5) Pass the tube and wires through the hole in the under cover
front bracket.
Check that the taped ends of the power tilt motor wire and
trim angle sensor wire are in alignment with the end of the
undercase grommet C.
Install the undercase grommet C on the under cover front
bracket so they engage securely in the groove of the
undercase grommet C.
Move the front lock with a hand and check that the wires
and tube do not interfere with the front lock.
[4]
UNDERCASE
GROMMET C
[11] SPEED
SENSOR
TUBE A
[7] Wires and tube must
not interfere with the
lock lever.
[6]
FRONT LOCK
[10]
TRIM ANGLE
SENSOR WIRE
[8]
TAPED
PARTS
[9] POWER
TILT
MOTOR
WIRE