18-12
[3]
ARMATURE
[4]
REAR
BRACKET
[2]
BRUSH
HOLDER
[1] YOKE/REAR BRACKET
ASSEMBLY
[2] THROUGH BOLT (2)
[1]
ARMATURE/REAR
BRACKET ASSEMBLY
[2]
YOKE
[5]
FRONT BRACKET
ASSEMBLY
[4]
PLATE
[3]
GASKET
[1]
5 x 8 mm SCREW (2)
2.5 N.m (0.25 kgf.m, 1.8 lbf.ft)
• REAR BRACKET/YOKE ASSEMBLY
1) Install the brush holder on the armature.
2) Apply grease to the armature shaft and install the gear
bracket as shown.
3) Apply the water resisting sealant (Sumitomo 3M Padding
Sealer #8533 or equivalent) to the seat of each 5 x 8 mm
screw.
Tighten the 5 x 8 mm screws to the specified torque.
TORQUE: 2.5 N.m (0.25 kgf.m, 1.8 lbf.ft)
4) Check the inner wall of the yoke for foreign material and
install the rear bracket/armature assembly.
• Install the rear bracket/armature assembly by aligning the
grommet with the cutout in the yoke.
5) Install the plate and gasket on the front bracket.
6) Install the yoke/rear bracket assembly.
• Install by aligning the projection on the yoke with the
cutout in the front bracket.
7) Apply the water resisting sealant (Sumitomo 3M Padding
Sealer #8533 or equivalent) to the seat of each through bolt.
Tighten the through bolts to the specified torque.
TORQUE: 5 N.m (0.5 kgf.m, 3.6 lbf.ft)
