17-19
13) Set the 12 mm washer on the shift shaft B and secure with
the 12 mm snap ring.
14) Apply marine grease to the outer surface of the link pin of the shift link bracket and to the long hole in the shift arm.
Set the link pin aligning with the long hole in the shift arm.
15) Tighten the shift link bracket assembly with the two 6 x 18 mm flange bolts securely.
16) Apply marine grease to the mounting part of the linkage pivot on the throttle plate and to the linkage pivot. Install
the linkage pivot on the throttle plate.
19) Remove the following parts.
– Remote control cable/grommet (P. 17-5)
– L./R. engine under covers (P. 4-14)
– Front separate cover (P. 4-7)
– Engine cover (P. 4-2)
[4] (MARINE
GREASE)
[4] (MARINE
GREASE)
[4] (MARINE
GREASE)
[2] THROTTLE
PLATE
[5]
SHIFT LINK BRACKET
ASSEMBLY
6 x 18 (2)
[3]
THROTTLE ROD
[2]
12 mm WASHER
[3]
SHIFT ARM
[Set in the “N”
(Neutral) position.]
[1]
12 mm SNAP
RING
[6]
LINK PIN
[1]
SHIFT ARM
