Honda 2010 CBF 250, Workshop Manual

Page: 85 / 291

DISMANTLING & INSTALLATION
OF THE ENGINE 6.
SERVICE INFORMATION 6-1
DISMANTLING OF SPROCKET OF TRANSMISSION 6-3
DISMANTLING/ENGINE Installation 6-4
Installing the SPROCKET OF TRANSMISSION 6-5
CBX250
SERVICE INFORMATION
GENERAL INSTRUCTIONS
•Used a crane or a proper support to support the motorcycle during dismantling and installation of the engine.
•Use a cat of flat or other support adjustable to support and bosoms motor.
•Encape the area around the chassis with adhesive tape before removing and installing the engine.
•Repairs and maintenance of the following components can be made with the engine installed in the chassis.
Alternator (Section 10)
camshaft (Section 7)
Carburetor (Section 5)
Clutch / Selector gears (Section 9)
Cylinder head / valves (Section 7)
pulse generator power (Section 17)
starter Motor /
clutch start (Section 18)
Cylinder / piston (Section 8)
oil pump (Section 4)
•To make repairs or maintenance in the following components must remove the engine.
Crankshaft / flywheel (Section 12)
Fork of the change / drum selector of gears (Section 11)
Transmission (Section 11)
•The following components must be removed before they remove the engine.
Exhaust pipe / silencer (Section 2)
Fuel tank (Section 2)
Tubes of oil (Section 4)
Carburetor (Section 5)
Cable clutch (Section 9)
Support the pedal support right (Section 14)
Connectors 3P and wiring of pulse generator of ignition / switch of deadlock (Section 17)
motor Cable start (Section 18)
Breather TUBE from the casing of the engine (Section 18)
Wiring breaker of deadlock (Section 17)
•After installing the engine, setting the following components:
Cable clutch (page 3-20) drive chain (page 3-14)
Cables of the accelerator (page 3-5)
Level of engine oil (page 3-11)