Honda 2010 CBF 250, Workshop Manual

Page: 232 / 291

HYDRAULIC BRAKE
CBX250
i
Before the assembly, bathe all the pieces with fluid brake
again.
Apply fluid brake to the piston. Install the spring in the
piston master cylinder. Install the whole piston in the cylin-
der master.
i
Install the ring of pressure in the slot on the master cylin-
der, using the special tool.
Special Tool: Pliers for rings of
pressure
07914-3230001
i
Make sure the ring of pressure is firmly established in
the slot.
Do not let the lips of the checkpoints are ori-
ented toward the outside.
The piston master cylinder, the checkpoints, the
spring, the ring of pressure and the protective rubber
should be replaced as a whole. Do not replace com-
ponents individually.
Install the protective rubber in the piston and in the cyl-
inder master.
Apply grease based on silicone to the surface of slippage bolt
pivot the brake.
Install the lever of front brake and the bolt pivot.
Install and tighten the nut pivot to the specified torque.
TORQUE VALUE:
Bolt pivot
6 N.m (0,6 kg.m)
Nut pivot 6 N.m (0,6 kg.m)
PISTÓN
PRIMARY CHECKPOINT SECONDARY CHECKPOINT
RUBBER PROTECTOR
NUT BRAKE HANDLE
PIVOT BOLT
PLIERS FOR RINGS
OF PRESSURE
RINGS OF PRESSURE
SPRING
S
FR
E
IO