Honda 2010 CBF 250, Workshop Manual

Page: 265 / 291

ELECTRIC STARTING SYSTEM
18-8
Install the brushes on the carries brushes. Install the
whole carries brushes in the lid rear, aligning its tongue
with the slot in the lid back.
NOTE
Install the following components:
New o ring
Shims
Washer
Nut
Keep the brushes pressured inside the carries brushes.
Then, install the induced in the casing for the starter motor,
through the carries brushes.
To install the induced in the casing for the starter motor,
then refasten firmly, in order to avoid the imam of the
casing or atraega.
i
Install the same number of s rear in the same positions that
have been observed and recorded during the disassembly.
Install a new o ring in the casing for the starter motor. Install
the lid rear, aligning its slot with the tab of the whole carries
brushes. Install the same number of s front in the same
positions that have been observed and recorded during the
disassembly. Install the washer of support and one new o ring
in the casing for the starter motor. Apply grease to lip catch
of oil and the ball needles the front flap. Install the washer
locks in the front flap. Install the front flap.
i
To install the front flap, be careful to the axle of
induced does not harm the lip of checkpoint of oil.
•Coil damage may occur in the event that the imam
atraega induced the meeting to the housing.
•Surfaces of slip of the brushes are destroy, in case
they are installed incorrectly.
Install correctly the shims, in accordance with what
you have observed during the dismantling.
BRUSH
BRUSH CARRIER
O-RING SHIMS BACK FLAP
ARMATURE CASING OF STARTER MOTOR
O-RING SHIMS NEEDLE
FRONT FLAP
O-RING
NUT WASHER BRUSH CARRIER
CBX250
SHIMS
Align
NUEVO
NUEVO
NUEVO