Honda 2010 CBF 250, Workshop Manual

Page: 56 / 291

MAINTENANCE
CBX250
WHEELS/TYRES
To verify if the bearings of the wheels are worn. For that
lock the wheels front / back and try move laterally. Replace
the bearings in the event that loose (refer to Section 13 or
14). Hold the fork. Raise of the front wheel of soil and
inspect with regard to idle. Turn the wheel and verify if
their rotation is soft, without abnormal sounds. In case of
wheel present a movement irregular or noise, inspect their
bearings. Support motorcycle firmly in a proper support
and to lift the rear wheel of the soil. Check the wheel, and
the swing arm with regard to idle. Turn the wheel around
and verify if their rotation is soft, without abnormal sounds.
In case of wheel present a movement irregular or noise,
inspect their bearings. If there are suspicions of abnormal
conditions, check the bearings in the rear wheel.
NOTE
NOTE
Check pressure, using a pressure gauge for tires.
PRESSURE RECOMMENDED AND THE DIMEN-
SION OF THE Tires
It should inspect the pressure on the tires COLD.
As the inspection swing arm is included in this proced-
ure, be sure to confirm the location of the slack, or is: if
the slack is presented in the bearings of the wheel or the
pivot swing arm.
PRESSURE GAUGE FOR Tires
Front Back
Dimension of tyre 100/80 17 52 S 130/70 17 62 S
Air pressure
Solo 225 (2,25; 33) 225 (2,25; 33)
(cold) kPa
With 225 (2,25; 33) 250 (2,50; 36)
(kgf/cm 2 , psi)
pillion
Make/Model Pirelli / MT75 Pirelli / MT75
Inspect the tires with regard to cuts, nails
embedded or other damage. Check the alignment of the
wheels front and rear (refer to the sections 12 and 14).
Measure the depth of furrowed in the centre of the tires.
Replace the tires in the event that the depth of furrowed
has reached the
limit of service:
minimum Depth of
tread: Front:
Until the wear indicator.
Back:
Until the wear indicator.