Honda 2010 CBF 250, Workshop Manual

Page: 227 / 291

HYDRAULIC BRAKE
15-4
PURGE OF AIR
Connect a hose of plastic in the valve to purge of the
clamp. Pump the brake until there is no more air bubbles
in the fluid from the cylinder master, and that the lever
offered resistance.
1. Activates the brake and open the valve purge 1/2 lap.
Then, closing the valve.
NOTE
2. Release slowly the brake and wait for a few seconds, until
it reaches the end of its course. Repeat steps 1 and 2 until
there is no more air bubbles in the hose to purge. Tighten
the valve to purge the pair specified.
TORQUE: 5 N.m (0,5 kg.m)
Supplying the deposit toward the mark of the higher level.
Do not release the brake until the valve purge has
been closed.
PURGE VALVE
Install the diaphragm, the plate of fixing and the
cover of the deposit. Tighten the screws.
TORQUE: 1 N.m (0,1 kg.m)
SCREWS
DISK/brake pads
REPLACEMENT OF THE brake pads
NOTE
Remove the caps of the pins of the pills and release the pins.
Remove the fixing bolts the clip of the brake.
Then, remove the clip of the brake.
Always replace the brake pads to pairs, so that the pres-
sure on the disk is uniform.
CAPS OF THE PINS OF THE SOMETHING OF
FIXING BOLTS THE CLIP OF THE brake
CBX250
SCREWS
TOP OF THE
RESERVOIR
FIXING PLATE
DIAPHRAM
HIGHER
LEVEL