Honda 2010 CBF 250, Workshop Manual

Page: 148 / 291

ALTERNATOR
CBX250
Apply oil to the thread and to the surface of settlement
of bolt the wheel of the engine. Then, install the washer
special and the bolt. Hold the wheel of the engine,
using the special tool. Then tighten the bolt to the spe-
cified torque.
Special tool:
Flywheel support
07725-0040000
TORQUE: 103 N.m (10,3 kg.m)
Install the lid left side of the casing of the engine.
Install the ears of guide and a new gasket.
Installing the STATOR/pulse generator power
Place the stator / pulse generator power in the lid left side of
the casing of the engine. Install the hub of rubber in the slot
of the lid left side of the casing of the engine, in accordance
with the illustration. Guided correctly the wiring and install
the screw the pin of the cable. Press the pin against the cap
on the local indicated, in a manner that precludes its
turnaround. Then, tighten. Tighten the bolts from the pulse
generator power together with the pin and the three bolts
stator.
TORQUE:
Bolt from the pulse generator
power
5 N.m (0,5 kg.m)
Bolt of fixing the stator 10 N.m (1,0 kg.m)
The Screw pin of cables
from the stator
10 N.m (1,0 kg.m)
INSTALLATION OF THE LID LEFT SIDE OF THE
CASING OF THE ENGINE
Apply oil to the washers and install in the machinery of
reduction in the boot.
Install the spiral of reduction in the boot.
FLYWHEEL SUPPORT
BOLT/WASHER SPECIAL
SPIRAL OF REDUCTION IN THE
BOOT/WASHERS
GUIDE SPIKES
GASKET
PULSE GENERATOR POWER
STATOR HUB OF RUBBER
SCREWS
BOLTS
A
C
E
IT
E
A
C
E
IT
E
NUEVA