Honda 2010 CBF 250, Workshop Manual

Page: 213 / 291

REAR WHEEL/BRAKE/SUSPENSION
14-12
Install the plate indicator of attrition in the cmea, aligning its
striated more width with the slot wide came from the brake.
STRIATED WIDE/SLOT WIDE
INDICATOR PLATE WEAR
SPRINGS
SHOTES
BOLT/NUT LOWER
BOLT/NUT HIGHER
Install the arm of brake, aligning the marks of punch in the arm
and in the came from the brake.
Install the bolt and nut in the arm of brake. Tighten to value specified.
TORQUE: 10 N.m (1,0 kg.m)
Position the brake pads
on the panel of the
brake and then, install
the springs.
i
NOTA
INSTALLATION
Install the whole of the panel of the brake in the rear
wheel. Then, install the wheel (page 14-8).
Setting the rear brake (page 3-19).
SUSPENSION
DISMANTLING
Remove the saddle (page 2-2).
Remove the side cover (page 2-2).
Support motorcycle firmly, using a cat of flat or other sup-
port equivalent.
Remove the nut and bolt fixing lower damper.
Remove the nut and bolt higher fixing cushion.
Then, remove the damper.
Case reuse pads, be sure to install them on its original
position.
Do not allow the grease scope the brake pads.
Align NUT BOLT
CAME FROM THE brake ARM TRIGGER FOR THE brake
CBX250