Hioki RM3542-50, Instruction Manual

Page: 25 / 234

1.3 Screen Organization
19
1
Measurement Settings screens
[MEAS SETTINGS]
Set instrument system-related settings on this screen.
SET MONITOR Two units measurement condition comparison
ON/OFF(p. 59)
PROBE CHECK Probe short-circuit detection function ON/OFF
(p. 57)
RETRY Retry function setting (p. 62)
VOLT LIMIT Sets voltage limit function to ON/OFF (p. 64)
TRIG EDGE (EXT. I/O) Set the trigger rising/falling edge
(p. 106)
EOM (EXT. I/O) EOM (end-of-measurement signal)
output setting (p. 105)
INTERFACE Communications interface settings(p. 113)
PRINT MODE Set printing method (p. 91)
LOW POWER Low-power resistance component
measurement ON/OFF(p. 28)
JUDGE BEEP Comparator beeper settings (p. 70)
KEY BEEP Key beeper ON/OFF (p. 69)
CLOCK (Y-M-D) Internal clock settings (p. 72)
LINE FREQ Power source frequency settings (p. 71)
CONTRAST Adjust screen contrast (p. 73)
BACKLIGHT Adjust screen backlight (p. 74)
RESET Initializing (p. 75)
ADJUST Instrument Adjustment (p. A13)
System screens
[SYSTEM]
Shows detailed settings for measurements.
Use when adjusting the measurement speed, stability and
measurement fault detection functions.
DELAY1 Adjust the delay between the probing and
trigger input (p. 44).
DELAY2 Adjust the target electrical response (p. 44).
SCALING
(A
*
R+B)
Compensate the measured value using scaling
function (p. 46)
INT(FAST/ MED/
SLOW) Make fine adjustment to the integration time
(p. 48).
CONT CHECK Contact check threshold setting (p. 50)
CONT IMP Contact improver function setting (p. 52)
VOLT MONITOR Voltage level monitor function setting (p. 55)
CURRENT
MODE Current mode setting (p. 56)
Data Memory Setting screen
(Save, analysis, output)
[DATA SETTINGS]
These are settings for memory and statistical calculation
functions.
AUTO MEMORY Auto-memory function ON/OFF (p. 81)
STATISTICS Statistical calculation ON/OFF (p. 84)
DATA OUT Auto-export the measurement values
(communication) ON/OFF (p. 87)
Detailed Settings