Hioki RM3542-50, Instruction Manual

Page: 119 / 234

9.4 Configuring the Communications Protocol
113
9
Configure the interface on the System screen.
External command operation is undetermined when the Printer is selected as the interface type. In
this case, commands should not be sent.
Make these instrument settings.
Configure the Controller (PC or PLC).
9.4 Configuring the Communications Protocol
Configuring RS-232C Interface Communications Protocol
1
Open the Basic Settings screen.
2
Open the System screen.
3
Select the interface type.
4
Select the interface transfer rate.
5
Return to the Measurement screen.
The Basic Settings screen appears.
The System screen appears.
[SYSTEM]
1
Selection
2
Selection
2
RS-232C Interface
1
Selection
2
9600 (bps) (default)
19200 (bps)
38400 (bps)
1
Returns to the setting screen.
Saves setting and return to previous screen.
Discards setting and return to previ-
ous screen.
The confirmation screen appears.
Be sure to set the controller as shown below.
•
Start-stop synchronization method
•
Transmission Speed: 9600bps/ 19200bps/ 38400bps
(Set it to match the setting of this instrument.)
•
Stop bit: 1
•
Data length: 8
•
Parity check: none