Hioki RM3542-50, Instruction Manual

Page: 111 / 234

8.4 Ext. I/O Settings
105
8
These settings affect the logic of the end-of-measurement and trigger signals.
Select whether the EOM (End-of-Measurement Signal) output level is retained until the next trigger
input, or set for the specified pulse width.
8.4 Ext. I/O Settings
Setting the End-of-Measurement Signal Output (EOM Signal Setting)
1
Open the Basic Settings screen.
2
Open the System screen.
3
Select the EOM signal output type.
4
(When PULSE is selected)
Set the pulse width.
5
Return to the Measurement screen.
The Basic Settings screen appears.
The System screen appears.
[SYSTEM]
1
Selection
2
Selection
1
2
The specified pulse is outputted after the
end-of-measurement (default).
The EOM signal is retained after the end-
of-measurement (go to step 5).
Setting range: 1 ms to 100 ms (default: 5 ms)
2
3
Selection
1
Returns to the setting screen.
Saves setting and return to previous screen.
Discards setting and return to previ-
ous screen.
The confirmation screen appears.