Hioki RM3542-50, Instruction Manual

Page: 221 / 234

Appendix 8 Table of Comparison Commands ADEX AX-162D / for this instrument
A
15
Appendix
Example 1
Measurement function: R mode
Measurement ranges: 10
Ω
Upper limit: 1.900 Ω
Lower limit: 1.100 Ω
Measurement speed: SLOW
Trigger after the above settings
Example 2
Measurement function: % mode
Reference resistance: 100 k
Ω
(Measurement range: 100 k
Ω
)
Upper limit: 10.00%
Lower limit: -10.00%
Measurement speed: FAST
Trigger after the above settings
AX-162D (Original mode) RM3542A
M1 :CALCulate:LIMit:MODE ABS
RNG2 :RESistance:RANGe 10
LH1900E-3 :CALCulate:LIMit:ABS 1900E-3,1100E-3
LL1100E-3
S0 :SPEEd SLOW
E *TRG
or
M1RNG2LH1900E-3LL1100E-3S0E
Note: Although no delimiters are shown, they must be included at the end of each command line.
AX-162D (Original mode) RM3542A
M0 :CALCulate:LIMit:MODE REF
:RESistance:RANGe 100E+3
3 :CALCulate:LIMit:REFerence 100E+3
LH+1000E-2 :CALCulate:LIMit:P1000E-2,-1000E-2
LL-1000E-2
S1 :SPEEd FAST
E *TRG
or
M3LH+1000E-2LL-1000E-2S1E
Note:
Although no delimiters are shown, they must be included at the end of each command line.
Even when the reference standard resistance is set on this instrument, the range is not automatically
selected.
Use the range setting command to set the same value as the reference standard resistance.
When setting the same value as the reference standard resistance using the range setting command, there
are cases in which the range is different from the instrument's auto-ranging selection, depending on the
value.