Hioki RM3542-50, Instruction Manual

Page: 193 / 234

Chapter 10 Specifications
187
10
(21) Reset Functions
(22) Self-Calibration Function
(23) Memory Function
(24) Auto-Memory Function
(25) Statistical Calculation Function
Reset
Operation Resets settings (except the clock) to factory defaults
∗
RST (Remote command)
Operation Resets settings (except the clock and interface) to factory defaults
When power is restored, reverts to the settings before
∗
RST was sent
Operation Compensates for offset voltage and gain of measurement circuit
Compensation timing When setting is changed and once every 10 minutes
Operation Measurement values are stored by an EXT. I/O TRIG signal or by pressing the F4
[MANU]
*
button
* Displayed when EXT is selected on the [MENU]-[TRG] selection screen
Default setting OFF
Setting ON/ OFF
Memory capacity 30,000 (volatile memory, no backup)
Operation Acquire once the measured value has stabilized using internal continuous trigger man-
ual measurement.
A beep will sound once the set count is reached.
Memory is cleared when acquired data has been transferred or printed by RS-232C
During Auto-Memory operation, the statistical calculation function is always enabled.
The voltage level monitor function is disabled.
Default setting OFF/ 10
Setting ON/ OFF
Number of measurements stored: 1 to 99
Operation Statistical calculations are performed on measurement values in memory.
Default setting OFF
Setting ON/ OFF
Calculations Total data count, Mean, Minimum value (sample no.), Maximum value (sample no.),
Standard deviation of sample, Population standard deviation, and Process capability in-
dices