Hioki RM3542-50, Instruction Manual

Page: 93 / 234

6.4 Auto-Exporting Measurement Values (at End of Measurement) (Data Output Function)
87
6
At the end of measurement, the measurement value is exported to a computer via RS-232C.
See: "Chapter 9 Communications (RS-232C/ GP-IB Interface)" (p. 109)
6.4 Auto-Exporting Measurement Values (at End
of Measurement) (Data Output Function)
• Set the interface to [RS232C] beforehand. This function is not applicable to the GP-IB Interface.
See: "9.4 Configuring the Communications Protocol" (p. 113)
• When internal [TRG: INT] triggering is selected, data is exported only when a TRIG signal is applied.
• Executing a :READ? query command exports duplicate measurement values.
• Even when using other queries, ensure that the query response and auto-exporting of measured values do
not overlap.
• The data format for measurement values can be selected as ASCII (default) or BINARY. Transfer time is
minimized when BINARY is selected.
See: ":SYSTem:FORMat <ASCii/ BINary>" (p. 150)
1
Open the Basic Settings screen.
2
Open the Data Memory Settings screen.
3
Enable or disable the function.
4
Return to the Measurement screen.
The Basic Settings screen appears.
The Data Settings screen appears.
[DATA SETTINGS]
1
Selection
2
Selection
1
2
Disables auto-exporting (default).
Enables auto-exporting.
Returns to the setting screen.
Saves setting and return to previous screen.
Discards setting and return to previ-
ous screen.
The confirmation screen appears.