Hioki RM3542-50, Instruction Manual

Page: 156 / 234

9.7 Message Reference
150
Description ON: The measurement value is automatically sent each time an externally triggered
measurement is finished.
During internal triggering, the measurement values are sent automatically whenever the
TRIG signal is applied.
OFF: The measurement values are not automatically sent.
This function cannot be used with GP-IB Interface.
Set and Query Measurement-Synchronized Data Output
Set and Query the measurement data format
Syntax Command
:SYSTem:FORMat
<ASCii/ BINary>
Query
Response
:SYSTem:FORMat?
<ASCII/ BINARY>
Description The data format for sending measurement values can be set to ASCII strings or binary data.
Note Binary format supports high-speed transfers, but requires binary data support on the
receiving end (p. 115).
When set in binary data format, the delimiter is not sent from this instrument.
Set and Query probe short-circuit detection
Enables/Disables Probe Short-Circuit Detection Function
Syntax Command
:SYSTem:4WCHeck
<1/ 0/ ON/ OFF>
Query
Response
:SYSTem:4WCHeck?
<ON/ OFF>
Probe Short-Circuit Detection Timing
Syntax Command
:SYSTem:4WCHeck:TIME
<Time for Detection>
Query
Response
:SYSTem:4WCHeck:TIME?
<Time for Detection>
<Time for Detection> = 0.001 sec to 0.1000 (NR2) sec
Description Probe short-circuit detection is performed after the specified time for detection following
end-of-measurement.
At the end of measurement, remove the probes from the measurement object within the
time specified for detection.
Example
:SYST:4WCH:TIME 0.01
Set and Query the Retry Function
Enables/Disables Measurement Retry Function
Syntax
Command
:SYSTem:RETRy
<1/ 0/ ON/ OFF>
Query
Response
:SYSTem:RETRy?
<ON/ OFF>
Example
:SYST:RETR ON
Set and Query the Retry Interval of the Measurement Retry Function
Syntax Command
:SYSTem:RETRy:TIME
<0.001 sec to 0.05 sec>
Query
Response
:SYSTem:RETRy:TIME?
<0.001 sec to 0.050 sec (NR2)>
Example
:SYST:RETR:TIME 0.02