Hioki MR8740, Instruction Manual

Page: 199 / 424

8.2 Setting the Trigger Mode
187
7
Cha
pter 8 T
rigger Set
tings
8
Set whether to continue to accept triggers after measuring.
If all trigger sources are disabled (Off, with no trigger setting), measurement starts immediately
(free-running).
Description
Available selections depend on the function.
To Stop Measuring:
Click
[STOP] in the right-click menu.
Click once: recording stops at the end of the specified recording length.
Click twice: recording stops immediately.
When the trigger mode is set to [Repeat]
During the processing interval from the end of recording until entering the next
trigger standby condition (Auto Save, waveform display processing, numerical
calculation), triggering will not be accepted.
8.2 Setting the Trigger Mode
Procedure
To open the screen: Right-click and select [DISP]
→
Waveform screen
1
Move the flashing cursor to the [Trigger] item.
2
Select the trigger mode.
Select
Single
Only one trigger is recognized. After measurement is start-
ed, once a trigger is applied, a waveform is recorded for the
specified recording length, and measurement then stops.
Repeat
Triggers are accepted continuously.
When no trigger is applied, the instrument enters the Trig-
ger Wait state. Click
[STOP] to stop measuring. (See be-
low)
Auto
Triggers are accepted continuously.
If no trigger is applied within about one second, a waveform
of the specified recording length is automatically recorded.
Click
[STOP] to stop measuring.
Trigger Mode
Function
Single
O O
(default setting)
Repeat O O
Auto
O
(default setting)
×