Hioki IM7580, Instruction Manual

Page: 287 / 340

279
General Specifications
Parameter
color change
function
This function enables display colors to be changed for measurement values.
Absolute
measurement
value display
function
Absolute measurement value display function for measurement values ( θ and ∆% excluded)
Key-lock
function
Can be enabled and disabled by front panel key operation.
Key lock is released by entering a passcode.
Memory
function
32000 LCR measurements and 100 ANALYZER sweeps can be saved in this instrument.
(Reading via RS-232C, GP-IB, USB, LAN or USB flash drive is possible.)
Beep sound Beep sound for the comparator judgment result (IN or NG) can be set to ON/OFF.
Beep sound for key input can be set to ON/OFF.
15 types of beep sounds are available.
I/O judgment
output
delay function
1. Delay from judgment result output to EOM
0.00000 s to 0.99999 s
2. Judgment result output reset timing modification function
IO trigger 1. This function enables trigger input during measurement.
2. Edge selection (rising, falling)
I/O EOM EOM signal output method (pulse, hold)
0.00001 s to 0.99999 s
Warm-up
function
A message appears 60 min after power-on.
(6) Compensation
Open/short/load
calibrations
(compensation to
test head)
ALL and SPOT available, compensation value check, compensation value read/write
possible
(ANALYZER: SPOT only)
Number of SPOT compensations: 5 (LCR), 801 (ANALYZER)
Open/short
compensations
(compensation to
test fixture)
ALL and SPOT available, compensation value check, compensation value read/write
possible
Number of SPOT compensations: 5 (LCR), 801 (ANALYZER)
ALL compensation or SPOT compensation works with open/short/load calibration.
Electrical length
compensation
Compensation range: 0.00 mm to 100.00 mm
Correlation
compensation
Enter the compensation coefficients a and b for the following expression.
[Measurement value after compensation] = a × [measurement value] + b
Setting range for a: -999.999 to +999.999
Setting range for b: -9.99999 G to +9.99999 G
12
Specifications