Hioki IM7580, Instruction Manual

Page: 192 / 340

184
Common Functions (LCR Mode, ANALYZER Mode)
Setting the parameter color
Sets the color for the graph of the measured values or measurement results to be displayed on the
screen for each parameter.
In addition, you can set a color for each segment in the case of segment sweep.
1
2
3
1
Press [SETUP] .
2
Press [COMMON] tab.
(Press [ADVANCED] tab for the ANALYZER mode.)
3
Press [DISP] .
5
6
4
4
Select the parameter to set the color.
The setting differs based on “4.3.1 Setting the
Sweep Method” (p. 76).
5
Select the color to set.
6
Press [EXIT] to close the setting screen.
All parameters are set in the same way.
When [SEGMENT] is set to [OFF] When the [SEGMENT] setting is [SEG ON] or
[SEG INTVL]
If you do not want to set colors:
The graph will not be drawn if you select OFF.
To set the color of segment 1 to all segments: Press
[SEG1 ALL]
.
To restore the colors of all segments to the initial state:
Press
[AUTO SET] .