Hioki IM7580, Instruction Manual

Page: 160 / 340

152
Calibration
5.2.2 Setting the Electric Length [LENGTH]
Compensation is performed for the error caused by the phase shift occurring between the
calibration reference surface and the measurement sample connection surface.
Enter the electric length between the calibration reference surface on which open calibration, short
calibration, and load calibration were performed for the surface where the measurement sample is
connected.
The guaranteed accuracy range differs depending on the electric length.
See “Electrical length compensation” (p. 279).
1
1
Press [ADJUST] .
2
2
Press [LENGTH] .
The numeric keypad can be
used for input.
4
3
3
Set the electric length with

/

or the numeric
keypad.
(when the numeric keypad is used, press [SET] .)
[C] Repeats the input.
[CANCEL] Cancels the setting.
4
Press [EXIT] to close the setting screen.