Hioki IM7580, Instruction Manual

Page: 175 / 340

167
Continuous Measurement Application Settings
6.5 Continuous Measurement Application Settings
6.5.1 Cancels the Measurement if an Error is Detected
When an error is detected during continuous measurement, select whether to cancel or continue
the measurement.
The measurement will be canceled if the set judgment functions of the panel satisfy the following
conditions.
LCR mode
• The comparator or BIN is enabled.
• If the judgment result is Fail (HI/LO/OUT).
ANALYZER mode
• Area judgment or peak judgment is enabled.
• If the judgment result is fail (HI/LO/OUT).
1
1
Press [SETUP] .
2
5
4
3
2
Press [COMMON] tab.
3
Press [ERR ABORT] .
4
Select OFF/ON.
[OFF]
Continuous measurement is performed
for all panels, irrespective of the judgment
results.
[ON]
The continuous measurement is canceled
when the judgment result is Fail.
5
Press [EXIT] .
When the contact check function has been set, the measurement will be canceled irrespective of the
settings mentioned above when all four of the following conditions apply.
See “7.1 Checking Contact Defects and the Contact State (Contact Check Function)” (p. 169).
• If the contact check timing has been set to [BEFORE] or [BOTH] .
• If LIMIT has been set.
• If ERR ABORT has been set to ON.
• If LIMIT judgment detected an error at the timing of BEFORE.
6
Continuous Measurement Function