Hioki IM7580, Instruction Manual

Page: 181 / 340

173
Checking Contact Defects and the Contact State (Contact Check Function)
9 10
11
9
Press [JDG EXEC] .
10
If the DC measured value is UNCAL, select
whether to perform a judgment or not.
[DO] Performs a judgment.
[NOT]
Judgment is not performed. The result is
HI.
11
Press [EXIT] to close the setting screen.
Judgment order
Judgment
order
Condition Judgment display
1 In case of not calibrated ( UNCAL ) HI
2
When judging if the measured value is higher than the lower limit value,
and the judgment is Fail.
LO
3
When judging if the measured value is lower than the upper limit value,
and the judgment is Fail.
HI
4 In case of other than 1, 2 and 3 IN
• When the measured value is not calibrated ( UNCAL ), judgment is performed according to the
judgment order if [JDG EXEC] has been set as [DO] . HI judgment is returned without performing
judgment if the setting is [NOT] .
• If you interchange the upper limit and lower limit values an error message will not be displayed
because the upper and lower limit values are not compared.
• Judgment is possible even if only one of the upper or lower limit value has been set.
When only an upper limit value
has been set
HI
IN
Upper limit value
When only a lower limit value
has been set
IN
LO
Lower limit value
7
Application Function