Hioki IM7580, Instruction Manual

Page: 117 / 340

109
Performing Measured Value Search
Setting target slope
Sets the target slope when
[TARGET]
is selected in the setting of search type.
1 2
1
Press [SLOPE] of the target cursor.
2
When executing a target search, set if search
has to be performed in rising waveform or falling
waveform for the value to be searched.
[UP] Searches in rising waveform.
[DOWN] Searches in falling waveform.
Filter settings
• This is set when [L-MAX] or [L-MIN] is selected for the search function setting.
• Set a filter to judge the local maximum value or local minimum value.
• Applying a filter allows you to reduce the misjudgments of variations in measured values caused
by noise and other interference being judged as local maximum values or local minimum values.
The filter setting is common to cursors A and B.
1 2
1
Press [FILTER] .
2
Select ON/OFF.
[OFF] Disables the filter function.
[ON] Enables the filter function.
4.7.3 Using the Auto Search Function
If you set the auto search function to [ON] , the search is executed after sweep measurement ends,
and the cursors automatically move in accordance with the search settings.
2 1
1
Press [AUTO SEARCH] .
2
Select ON/OFF.
[OFF] Disables the auto search function.
[ON] Enables the auto search function.
4
Analyzer Function