Genesis GEN3t, User Manual, Page: 190 / 1124

1 Connect equipment (See Figure 11.26)
Connect the PC to the optical Ethernet connector of the GEN DAQ system
via an optical Ethernet connection. Connect the NAS to the GEN DAQ
system via the standard RJ45 connection or, if the option is installed, use
a second optical Ethernet connection.
OR
Connect the PC to the GEN DAQ system
’
s standard RJ45 connector via
a standard RJ45 Ethernet connection. Connect the GEN DAQ system to
the NAS server
’
s optical Ethernet connector via the optical Ethernet
connection.
For information on setting up the GEN DAQ, please refer to "Connecting
the GEN series directly to your PC" in the GEN DAQ manual.
At this stage, make sure that all connections and configurations are
correct. The GEN DAQ should resolve an auto IP address within a few
moments after being powered on. Then the NAS should be configured with
Perception. To configure the NAS, first connect a network cable or connect
the NAS to a network temporarily. Then follow manufacturer's guidelines.
An IP address for the NAS server can now be determined.
Note All IP addresses are best set to a fixed IP address.
2 Setup in Perception: (See Figure 11.27)
Start Perception, navigate to the Settings menu and select External
Storage Setup .
GEN3t
190 I3995-3.1 en HBM: public