Figure 11.25:
Storage location with options
11.5.12
Set up an iSCSI NAS connected without an Ethernet switch
This is a basic setup of a GEN DAQ system with a NAS connected directly to
the GEN DAQ system. An Ethernet switch is not required. In this setup, only
the GEN DAQ system can communicate with the iSCSI NAS. This is therefore
the most secure way to set up the NAS storage device.
However, this setup does not provide the network connection to be able to
configure the NAS storage device.
Optical Ethernet connection
Ethernet connection
(or if the option is installed use
a second Ethernet connection)
NAS
Figure 11.26:
GEN DAQ attached directly to iSCSI NAS
WARNING
The NAS is NOT configurable in this setup. The unit therefore has to be
connected to a PC first to assign an IP address manually. Alternatively, a
connection to the company network can be created, and then later
removed, if necessary.
GEN3t
I3995-3.1 en HBM: public
189