G.3.5
GEN3i/GEN7i with PTP network switch and four or more of QuantumX "B"
version modules
Figure G.12:
GEN3i with multiple MX1609KB/MX1609TB
-
Using PTP switch
Note
Setup only shows GEN3i. GEN3i can be replaced by GEN7i.
Note
* Multiple QuantumX modules requires more than one power supply; see
QuantumX documentation.
HINT/TIP
This setup is preferred as it doesn't require any manual network setup. However
it does require a PTP switch.
HINT/TIP
Perception V6.72 allows the PTP synchronisation within the GEN series
mainframes to be reduce to lower accuracies. With the lower sample rates used
within the QuantumX this might be very acceptable within your application.
Normal switches without PTP support can then be used without PTP
synchronisation error reports.
GEN3t
I3995-3.1 en HBM: public
881