260
6. In-service maintenance
Replacing front windshield wiper blades
-
Set the vehicle power switch to the “ON”
position and then to the “OFF” position.
-
Set the wiper combination switch to MIST
within 10 s. The wiper arm will stop after
running for half a circle.
NOTE
With the wiper switch in the “OFF”
position, if the soft button on the right of
“Wiper Maintenance Mode” is touched
on the AV system “Settings→Body
Accessories→Other Accessories” interface,
the wiper arm will stop after moving for half
a circle. If the soft button on the right is
touched again, the wiper arm will be reset.
-
Lift up the wiper arm, and press the lock
button as arrowed to remove the wiper
blade.
-
Disconnect the wiper blade from the
washer hose, and remove the wiper
blade.
-
Slowly lower the wiper arm.
-
Install the new wiper blade into the wiper
arm in reverse steps. It is installed in
place when a “click” is heard.
-
Gently put the wiper arm back on the
windshield.
-
Set the vehicle power switch to the “ON”
position or start the engine. Then the
wiper automatically returns to the original
position.
