115
4. Operation of systems and equipment
Rear windshield defrost/defog function
If the
button is pressed, the rear windshield
defrost/defog function will be activated, and the
rear windshield will be electrically heated.
If the
button is pressed again, the rear
windshield defrost/defog function will be
deactivated. If you do not manually turn off
the rear windshield defrost/defog function, this
function will be automatically deactivated after
15 minutes.
NOTE
● With the engine shut down, using the
rear windshield defrost function for a
long time will cause low battery voltage,
making it impossible to start the engine.
● The rear defrost function is limited to
ensure starting performance under low
battery.
Air supply mode
Front air supply mode
Click the air supply mode button on the front A/
C control interface of the AV display or in the
resident toolbar at the bottom of the AV display
to adjust the front air supply mode.
Switch the AV system to the A/C system control
interface, click the soft key to switch the
air supply mode manually; in the AUTO mode,
the A/C system will automatically control the
air supply mode, and when the soft key is
pressed, the system will exit the AUTO mode.
When manually selecting through the front A/C
control interface, click the soft key to switch
cyclically according to the following air supply
modes:
-
Panel mode: Air flows out from the
panel outlets.
-
Panel/floor mode: Air flows out from
the panel and floor outlets.
-
Floor mode: Air flows out from the
floor outlets.
CAUTION
● When the temperature is set to the
lowest, the defrost/defog function
will cause the outer surface of the
windshield to mist up, affecting the
driver’s visibility and probably causing
serious accidents. To use the defrost
function, it is recommended to set the
temperature to a hot or warm position.
● When using the defrost/defog function,
if you manually turn off the A/C cooling
function, it will cause the front windshield
to mist up, affecting the driver’s visibility
and probably causing serious accidents.
● To use the defrost and defog functions,
for quick defrosting and defogging,
the default air volume level is higher
than 5, and the noise of the air outlet is
relatively large. If you want to reduce
the noise, you can manually reduce the
air volume on the premise of ensuring
the driver’s sight.
