217
5. Driving guide
5.5 Parking assist system
(PAS)
5.5.1 Reversing parking aid (RPA)
system
The RPA sends and receives the ultrasonic
waves through RPA sensors and uses the
ultrasonic waves sent and reflected by
obstacles to measure the distance between
the vehicle and obstacles.
On and Off
-
When the ENGINE START/STOP button
is in “ON” position, and the vehicle runs
at a speed less than 10km/h with parking
brake released and gearshift lever set to “R”
position, the RPA will start working.
-
When the forward speed is less than 10km/
h, the front ultrasonic sensor starts to
operate; when the forward speed is greater
than 12km/h, the front ultrasonic sensor
stop operating; when the forward speed
decreases from 12km/h above to below
10km/h, the front ultrasonic sensor starts to
operate again.
-
When the vehicle speed is greater than
12km/h, the front and rear ultrasonic sensors
will stop working; move the gearshift lever
out of the “R” position, and apply the parking
brake, so the ENGINE START/STOP button
will exit the “ON” position and the reversing
parking aid system is out of work.
-
When the RPA is activated during
reversing, the audible alarm can be turned
off and on manually by clicking the soft
key
①
. The audible alarm of the RPA
will be on by default when the engine is
restarted.
NOTE
It is recommended that the RPA audible
alarm is activated during reversing.
Dynamic view*
The dynamic view on the left of the display
shows the distance between the front/rear of
the vehicle and the obstacle. In the figure, the
indication sectors of radar of the vehicle is red-
orange-yellow-yellow from inner side to outer
side. When an obstacle is getting closer and
closer to the vehicle, the color sections will
gradually reduce from the outermost.
Change of dynamic view is synchronized with
that of the distance audible alarm.
