Fuji Xerox Document Centre C250, User Manual

Page: 257 / 556

Common Settings
255
Setups
11
Auto Clear
If a given time period elapses with no operation, the machine automatically returns to
the initial screen.
Set a period from 1 to 4 minutes, in intervals of 1 minute. In order not to set this, select
[No].
Note • When using the Build Job function, the settings will be cleared after 1 minute, even if you set
the time for longer.
1
Select [Auto Clear], and select
[Change Settings].
2
Select [Off] or [On].
3
If you selected [On], set the time
interval.
Auto Job Release
Set the time that elapses when, during a copy or scan, an error (paper feed, original
jam, copy jam, etc.) occurs, until the current job is cleared, enabling the next job. At this
point, jobs that can be continued are limited to those that only use parts of the machine
not affected by the error.
Set the value in the range 4 to 99 minutes, in 1 minute increments. In order not to set
this, select [No].
1
Select [Auto Job Release], and
select [Change Settings].
2
Select [Off] or [On].
3
If you selected [On], set the time.
Auto Print
When a certain time has elapsed with no operation, a print job can be automatically
started. Set this time.
Set the value from 1 to 240 seconds, in one second steps. If you select [No], once the
machine is ready, printing can start immediately.
1
Select [Auto Print], and select
[Change Settings].
2
Select [Off] or [On].
3
If you selected [On], set the time.
Auto Power Saver
In power saving mode, there is a "low-power mode" and a "sleep mode," and when the
set time has elapsed, these modes are switched to in the following way, thus reducing
the power consumption.
Last operation on the machine
J
Low-power mode
J
Sleep mode
1
Select [Auto Power Saver], and
select [Change Settings].
2
Set low-power mode and sleep
mode.