Fuji Xerox Document Centre C250, User Manual

Page: 511 / 556

HP-GL2 Emulation
509
Ap
pendix
17
Vertical Position
Adjustment 113 0 (Default): Do not 1 - 500: -250 ~ +250mm
Moves the hard clip area vertically.
-1 ~ -250mm for setting numbers 1 - 250
+1 ~ +250mm for setting numbers 251 - 500
Horizontal Position
Adjustment 114 0 (Default): Do not 1-500: -250 ~ +250mm
Moves the hard clip area horizontally.
-1 ~ -250mm for setting numbers 1 - 250
+1 ~ +250mm for setting numbers 251 - 500
Print Quantity Setup 115 0 (Default): Protocol
1: Panel
2: Command
Sets the method for specifying the print quantity.
HP-GL Mode 150 0 (Default): HP-GL
1: HP-GL/2
A graphics language can be selected.
Hard Clip 151 0: Standard
2 (Default): Paper
Sets the size for the area where drawings can be made
(hard clip area).
[Standard]...Hard clip area for A4, A3, letter, and ledger
are the same as for the Hewlett Packard HP7550A. Hard
clip area for other paper sizes is the same as this M/C
printable area.
[Paper]...Make the hard clip area the same area as the
paper.
Eject Command 152
(SP)
153
(SPO)
154
(NR)
155
(FR)
156
(PG)
157
(AF)
158
(AH) 0 (Default): OFF
1: ON
Sets the command that indicates a drawing is finished.
When the command specified here is received, drawing
is terminated and the paper is ejected.
[Off]...Does not process as an eject command.
[On]...Processes as an eject command.
ON is set as the default for SPO only.
Scaling 159 0: OFF
1 (Default): ON
Determines the setting to either enlarge or reduce the
document size so that the document size fits the paper
size.
[OFF]...Prints in the same size without enlargement/
reduction, even if the document size and paper size are
different.
[ON]...Prints while enlarging/reducing the data on
document size so that it fits the paper size.