Fuji Xerox Document Centre C250, User Manual

Page: 439 / 556

Image Quality Problems
437
Probl
em
So
lving
16
Image Quality Problems
When image quality of the printed result is poor, choose the closest symptom in the
following table, and perform the required remedy.
If image quality is not improved by performing the relevant remedy, contact our
Customer Support Center.
Symptoms Check Remedy
The copy is dirty. Is the document glass or the
document cover dirty? Clean the document glass or the document
cover.
Refer to "Cleaning the Document Cover and
Document Glass" (P.421).
Is the document made of
highly transparent material
like a transparency? If the document is highly transparent,
marks on the document cover will be
copied. Place a white sheet of paper on the
document and make a copy.
Is the document colored, of
a rough texture or a
blueprint? Either adjust the copy density or image
quality and then retry copying.
Refer to "Image Quality" (P.61), "Lighten/
Darken /Contrast (Adjusting the Copy Density
and Contrast)" (P.63).
Are you making copies of
glossy printing paper? Glossy printing paper easily sticks to the
document glass, and shadows are
sometimes copied and reproduced as dirt.
Place a transparency or highly transparent
film under the document and retry copying.
The copy has
black lines Is the scanning glass on the
feeder dirty? Clean the document glass.
Refer to "Cleaning the Film and Document
Feeder Glass" (P.422).
The copy is too
dark. Is the copy density set to
[Dark]? Adjust the copy density.
Refer to "Lighten/Darken /Contrast (Adjusting
the Copy Density and Contrast)" (P.63).
The copy is too
light. Is the density of the
document too light?
Is the copy density set to
[Light]?
The copy shifts
slightly. Is the paper shifting or is the
leading edge of the paper
not loaded flush with the
tray corners? Align the edges of the paper, and load the
paper again so that is flush against the
paper tray corners.
Refer to "Loading Paper" (P.232).