6-C2
Appendix C to Section 6: 9100 System Operation — IEEE 488.2 Common Commands and Queries
Final Width = 215mm
6.C.2
Event Status Enable
This event status data structure conforms to the IEEE 488.2 standard requirements for this structure.
∗
ESE enables the standard defined event bits which will gener-
ate a summary message in the status byte. Refer to Section 6;
Subsection 6.5.
Nrf is a Decimal Numeric Data Element representing an integer
decimal value equivalent to the Hex value required to
enable the appropriate bits in this 8-bit register. The
detailed definition is contained in the IEEE 488.2 standard
document. Note that numbers will be rounded to an
integer.
Execution Errors:
None.
Power On and Reset Conditions
Not applicable.
6.C.3
Recall Event Status Enable
This event status data structure conforms to the IEEE 488.2 standard requirements for this structure.
Execution Errors:
None
Power On and Reset Conditions
The Power On condition depends on the condition stored by the
common
∗
PSC command - if 0 then it is not cleared; if 1 then the
register is cleared. Reset has no effect.
∗
ESE?
recalls the enable mask for the standard defined events. Refer
to Section 6; Subsection 6.5.
Response Decode:
The value returned, when converted to base 2 (binary), identifies
the enabled bits which will generate a summary message in the
service request byte, for this data structure. The detailed
definition is contained in the IEEE 488.2 document.
∗
ESE
Nrf
phs
∗
ESE?
