Section 8: Model 9100 — Routine Maintenance and Test
8-1
Final Width = 215mm
Section 8
Model 9100 — Routine Maintenance and Test
Section 8 gives first-level procedures for maintaining a Model 9100, performing the Selftest operations and dealing with their
results. We shall recommend maintenance intervals, methods and parts, and detail the routine maintenance procedures. Section
8 is divided into the following sub-sections:
8.1
About Section 8
8.2 Routine Maintenance and Repair.
8.2.1 General Cleaning
8.2.2 Air Intake Filter — Description and Maintenance
Intervals
8.2.2.1 Removing the Instrument Top Cover
8.2.2.2 Calibration Seal — Caution!
8.2.2.3 Removing the Filter Element
8.2.2.4 Cleaning the Filter Element
8.2.2.5 Refitting the Filter Element
8.2.2.6 Refitting the Top Cover
8.2.2.7 Replacement Parts
8.2.3 Firmware Upgrade — Procedure
8.2.3.1 Introduction
8.2.3.2 Procedure
8.2.4 Fuse Replacement — Procedure
8.2.4.1 Introduction
8.2.4.2 Replacement Fuses
8.2.4.3 Diagnosing Blown Output Fuses
8.2.4.4 Replacing Hi and Lo Terminal Fuses
8.2.4.5 Replacing I+ and I- Terminal Fuses
8.3 Model 9100 Test and Selftest
8.3.1 Types of Test
8.3.1.1 Entry to Test Mode.
8.3.2 Fast/Full Selftest
8.3.2.1 Aborting the Selftest.
8.3.2.2 Selftest Runs to Completion.
8.3.2.3 Viewing the Test Results.
8.3.2.4 Printing the Test Results.
8.3.3 Selftest at Power-on.
8.3.4 Interface Test.
8.3.4.1 Access to Interface Tests.
8.3.4.2 Display Memory Checks.
8.3.4.3 Keyboard Checks.
8.3.4.4 Display Checks.
8.3.4.5 Memory Card Checks.
8.3.4.6
Serial Mouse
Checks.
8.3.4.7 Printer Checks.
8.4 Printing Selftest Results.
8.4.1 Parallel Port J103.
8.4.2 Printing Setup.
8.4.2.1 Printer Type.
8.4.2.2 Data Formatting.
8.4.3 Results Printout.
Appendix A: Error Reporting Subsystem.
